Adding DHCPv6 raw options - BlueCat Integrity - 26.1.0

The DHCPv6 raw option allows you to add DHCPv6 options that aren't directly supported by Address Manager.

1. Navigate to the object (i.e. server, network) that you are adding a DHCPv6 raw option to.
2. Select the Deployment options tab.
3. Select New > DHCPv6 raw option.
4. Under General, select the option and set its parameters:
   • Raw data—enter the raw option data. The maximum supported characters are 65,536.
5. On the Servers tab, select the servers or server group to which the option applies:
   • All servers—applies the deployment option to all servers in the configuration.
   • Server group—applies the deployment option to a specific server group in the configuration. Select a server group from the drop-down list.
     Attention: You cannot configure DHCP deployment options on a multi-primary server group.
   • Server—applies the deployment option to a specific server in the configuration. Select a server from the drop-down list.
     Attention: You cannot configure DHCP deployment options on servers that are part of a multi-primary server group.

   Note: You can't override deployment options set at the configuration level from the server group level if the deployment option is applied to a specific server within a server group.
6. In the Change control section, add comments if required.
7. Select Create or Create and add another.