Adding VLAN interfaces to xHA pairs from the Address Manager user interface - BlueCat Integrity - 26.1.0

Address Manager Administration Guide
ft:locale
en-US
Product name
BlueCat Integrity
Version
26.1.0

Add multiple VLAN interfaces to the Service interface (eth0) of an xHA pair. Ensure that IP addresses are unique and don't conflict with IPs configured on other interfaces of the server or in your network.

Note: If you need to add VLAN interfaces to a service interface other than eth0, such as bonding interface, you must configure the Primary Service IP and parent VLAN interface from the Administration Console of the Active Node. For details, refer to Setting the Primary Service IP address.

To configure VLAN interfaces on an xHA pair:

  1. Select the Servers tab in the sidebar, then select Servers.
  2. Select the name of an xHA pair.
  3. Select the Services tab.
  4. Under Server management and configuration, locate the Interfaces service panel and select Edit service.
  5. Select an interface tab, such as eth0.
  6. Under VLANs, enter a VLAN ID between 1 and 4096.
  7. Select Add VLAN.
  8. In the Description field, enter a name for the VLAN interface. You can enter up to 80 alphanumeric characters including spaces, but excluding special characters.
  9. In the Address and Prefix length fields, enter an IPv4 or IPv6 address and prefix length. For example, Address: 192.0.2.100 and Prefix length: 24 or Address: 2001:db8::AC10:FE02 Prefix length: 64. This will be the IP address assigned to the newly created VLAN interface.
  10. Select the Add (+) button.
  11. Select Save.
Note: Editing or deleting VLAN interfaces on an xHA pair is the same as standalone DNS/DHCP Servers. For details, refer to Configuring VLAN interfaces.