Adding a parent IPv4 block - BlueCat Integrity - 26.1.0

You can add a parent block to existing IPv4 blocks in Address Manager.

You can select two or more blocks on the same IPv4 blocks table to be located under a new parent block. The new parent block appears on the IPv4 blocks table where the siblings were selected, and the siblings now appear as children of the new parent block.

Attention: In previous versions of Address Manager, the create parent block operation was not allowed if an unselected block was present between the two selected blocks. In Address Manager v25.1, this operation will create a parent block containing the selected blocks and any unselected blocks within the range.

To add IPv4 parent blocks:

1. Select the IPAM tab in the sidebar, then select IPv4 blocks.
2. Navigate to the IPv4 blocks or IPv4 blocks and networks table that contains the IPv4 blocks you wish to add a parent block to.
3. Select the check boxes for two or more IPv4 blocks.
4. Select Action > Create parent block.
5. Under General, set the name and location for the block:
   • Name—enter a name for the new parent block to be added.
   • Location—(Optional) select a location from the drop-down menu on which the IP object that you are adding or editing will be based.
6. In the Change control section, add comments if required.
7. Select Save.