Adding and editing devices - BlueCat Address Manager - 9.0.0

Address Manager Administration Guide

prodname
BlueCat Address Manager
version_custom
9.0.0

Add a device to your network and assign a previously configured device type and subtype and IP address.

To add or update a device:

  1. Select the Devices tab. Tabs remember the page on which you last worked, so select the tab again to ensure you're on the Configuration Information page.
  2. Choose one of the following tasks:
    • To create a new device, or edit a device:
      1. To create a new device, under Devices, click New. To edit a device, click the device name, then under the device name menu, click Edit.
      2. Under General, complete the following:
        • Device Name—enter a descriptive name for the device.
        • Device Type—from the drop-down menu, select a device type. Device subtypes are listed by the device subtype name followed by the device type name in [square brackets]. Device type names are listed at the bottom of the drop-down menu. When editing a device, you can click the hyperlinks to jump to the Device Type page, Device Subtype page, or click Change Record to select a new device type from the drop-down menu
      3. Under IP Addresses, enter an IPv4 address in the Address field, and then click Add Another.
        • The IP address appears in a list beneath the Address field. Repeat this step to add more IP addresses to the device.
        • To remove an IP address, click Remove beside an address.
      4. Under Change Control, add comments, if required.
      5. Click Add or Update.
    • To remove a device:
      1. Under Devices, select the check box for one or more devices you want to remove.
      2. Click Action, then select Delete Selected.
      3. Click Yes.