Adding or removing the xHA backbone connection - BlueCat Address Manager - 8.3.1

Address Manager Administration Guide

prodname
BlueCat Address Manager
version_custom
8.3.1

Configure the xHA backbone on eth1 for data synchronization between nodes in an xHA pair.

If you did not already configure the xHA backbone connection when adding an DNS/DHCP Server or creating your xHA pair, you can add the xHA backbone connection without needing to break xHA.

Attention: Make sure to configure the IPv4 address of the xHA interface (eth1) on a different subnet than any other interface. This is the recommended best practice for direct xHA backbone connections and connections over switches or wide area networks (WAN). This isn't mandatory if you're using a direct connection to the eth1 interface on each DNS/DHCP Server. For information and assistance on running xHA with switches, contact BlueCat Customer Care. For details on creating an xHA pair in Address Manager, refer to Managing xHA.

If you have re-configured your network implementation and want to re-allocate the xHA interface (eth1) on your DNS/DHCP Servers, you can remove the xHA backbone connection from your xHA cluster.

Note: When the xHA backbone connection is disabled, the IPv4 address assigned to the xHA interface (eth1) remains on the node. Viewing the interface details of the respective DNS/DHCP Server nodes allows you to view the xHA backbone IPv4 address and netmask. For details, refer to Viewing xHA status.
Note: You can disable the xHA backbone without breaking xHA.

To add or remove the xHA backbone connection:

  1. Select the Servers tab. Tabs remember the page you last worked on, so select the tab again to ensure you're on the Configuration information page.
  2. From the configuration drop-down menu, select a configuration.
  3. Under Servers, click a server name. The Details tab for the server opens.
  4. Click the menu beside the xHA pair name and select Edit.
  5. To enable backbone communication, follow these steps:
    1. Under XHA Communication Interface, select the Enable XHA Backbone Communication check box. If you previously configured the xHA backbone when adding the DNS/DHCP Server or creating xHA, the IPv4 addresses and netmasks for the Active and Passive nodes will be pre-populated with the existing values.
    2. If this is your first time configuring the xHA backbone connection, enter the IPv4 address and netmask for the Active and Passive servers.
  6. To remove the backbone connection, under XHA Communication Interface, deselect the Enable XHA Backbone Communication check box.
  7. Click Update.