Configure an IPv4 address, netmask, and default gateway on the eth0 interface in order to connect the DNS/DHCP Server to the network so that you will be able to add it to Address Manager.
Note: For BlueCat
appliances, refer to the installation poster provided for
complete hardware installation information. For BlueCat virtual
machines, refer to the VM Installation
Guide.
Note: For complete
information on configuring interfaces from the Administration
Console, refer to Interface settings.
To set an IPv4 address, netmask, and default gateway:
- From Main Session mode, type configure interfaces and press ENTER.
- Type modify <interface> and press ENTER.
- Type set address <ipv4address/CIDR> and press ENTER.
- Type save and press ENTER. The Administration Console saves your settings.
- Type exit and press ENTER until you return to Main Session mode.
- Type configure network and press ENTER.
- Type set default-gateway <ipv4address> and press ENTER. If your gateway doesn't match your interface, you will receive an error. Enter the set gateway command again with the correct gateway address, or modify the IP address in Interfaces Configuration mode.
- Type save and press ENTER. The Administration Console saves your settings.
- Type exit and press ENTER until you return to Main Session mode.
- Any customers who require Dedicated Management in their environment should enable Dedicated Management before adding the DNS/DHCP Server to Address Manager. For details refer to Configuring Dedicated Management.
- If you don't require Dedicated Management, proceed to adding your DNS/DHCP Server to Address Manager.