You can configure network redundancy through port bonding on 4-port DNS/DHCP Server appliances only.
For most scenarios, BlueCat recommends enabling network redundancy using Address Manager when adding or replacing a server (for details, refer to Enabling DNS/DHCP Server Network Redundancy from the Address Manager user interface). However, if you want to configure port bonding with VLAN tagging, BlueCat recommends configuring a bonding interface from the DNS/DHCP Server Administration Console.
Supported bonding modes
- Failover— Active/Backup bonding where only one interface in the bond is active (Primary). This allows the secondary interface (eth3) to take over transparently if the Primary interface (eth0) fails.
- Load Balancing—Active/Active bonding using industry
standard 802.3ad aggregation protocol, where aggregation groups share the same speed and
duplex settings. Each interface shares the throughput and each interface is active;
neither interface is a primary nor a secondary.Note: Active/Active (802.3ad) load balancing must be enabled from the Address Manager user interface when adding or replacing a DNS/DHCP Server. If enabling Active/Active load balancing, you must first enable Active/Active on the DNS/ DHCP Server from Address Manager, then configure Active/Active (802.3ad) on your network switch. This protects against loss of connectivity with the DNS/DHCP Server.