The configure database command allow you to change the
database settings.
Attention: You must not use any of the configure
database commands on the Primary or Standby servers while database
replication is initializing.
-
From Main Session mode, type configure database and
press ENTER.
-
Press Tab to view a list of available commands, or type
? to view a description of each available item:
- add—add host to access the primary database, or
add an identity map entry for peer authentication
- delete—remove host access to the primary
database, or remove an identity map entry
- exit—exit database configuration with check for
any unsaved changes
- help—display help
- history—display the current session’s command
line history
- reset—disables replication and places database in
standalone mode
- save—save changes to database configuration
- set—set the local authentication method
- show—show database details