This task describes how to configure speed, duplex and auto-negotiation settings.
BlueCat strongly recommends keeping speed, duplex, and auto-negotiation at their default settings. However, we recognize that sometimes it is necessary to configure these options for network environments that use switches that need specific speed and duplex settings rather than automatically negotiated settings.
- Address Manager—eth0, eth1 (network redundancy; hardware appliances only)
- DNS/DHCP Server—eth0, eth1 (xHA Backbone), eth2 (Dedicated
Management), eth3 (hardware appliances only), bond0*, vlan-interface** (IPv4
*Only available once a bonding interface has been created (port bonding on hardware appliances only).
**Only available when VLAN interfaces have been configured.
You must set the speed and duplex manually if you are using Crossover High Availability (xHA). To ensure trouble-free HA operation, set the speed to 100 and set full duplex on the DNS/DHCP Server and on the switch you are using.
To configure speed, duplex, and auto-negotioation settings:
- From Main Session mode, type configure interfaces and press ENTER.
- Type modify <interface> and press ENTER.
- Type set speed <10|100|1000> and press ENTER.
- Type set duplex <full|half> and press ENTER.
Type set autoneg <on|off> and press
Note: Autonegotiation is a requirement for using the 1000BASE-T standard. To set the speed at 1000 Mbits/sec you must first set autonegotiation on.
- Type save and press ENTER. The Administration Console saves your settings.
- Type exit and press ENTER until you return to Main Session mode.
Proteus> configure interfaces Proteus:configure:interfaces> modify eth0 Proteus:configure:interfaces> set speed 100 Proteus:configure:interfaces> set duplex full Proteus:configure:interfaces> set autoneg off Proteus:configure:interfaces> save Save interface details for eth0