Creating an event registry - BlueCat Integrity - 26.1.0

From the Event settings page, you can configure Integrity Events settings, enable or disable the Events API, and add/edit/remove event registries.

1. Select the Settings tab in the sidebar.
2. Under Notification settings, select Event settings.
3. Select New event registry.
4. Select Enable event registry.
5. On the General tab, configure the following options:
   • Name—enter a name for the event registry.
   • Subject—enter a subject name for the event registry.
     Note: This text will be included in the subject field of every event created through this registry. Only use letters, numbers, hyphens, and underscores.
     Attention: If a change is made to an object linked to multiple event registries, only one event will be sent, however this event will contain the Subject for each registry it is linked to.
6. On the Object types tab, select the type(s) of object that will produce events for the registry. The following options are available:

   IPAM objects

   • Select all IPAM object types
     • IPv4 block
     • IPv4 network
     • IPv4 address
     • IPv4 DHCP range
     • IPv4 DHCP lease
     • IPv6 block
     • IPv6 network
     • IPv6 address
     • IPv6 DHCP range
     • IPv6 DHCP lease

   DNS objects

   • Select all DNS object types
     • View
     • Zone
     • Host record
     • Alias record
     • Text record
     • Host information record
     • Service record
     • Mail exchange record
     • Naming authority pointer record
     • Hypertext transfer protocol secure record
     • Service binding record
     • Uniform resource identifier record
     • Generic record
7. On the Change control tab, enter a comment if required.
8. Select Create or Create and add another.