BlueCat recommends that all customers enable / disable Address Manager network redundancy from Address Manager. However, you can also disable network redundancy from the Address Manager Administration Console by removing the bond0 interface.
To disable Address Manager network redundancy:
- Log in to the Address Manager Administration Console as the administrator. For more information on default login credential for Address Manager, refer to BlueCat default login credentials (you must be authenticated to view this topic).
- From Main Session mode, type configure interfaces and press ENTER.
- Type remove bond0 and press ENTER.
At the prompt, type <Y|y> and press
This operation will disconnect SSH connections.
To verify that bonding is disabled, type show and press
Proteus> configure interfaces Proteus:configure:interfaces> remove bond0 Please confirm the removal of requested interface (Y/y or N/n)? Y This operation will disconnect SSH connections Removed interface successfully Proteus:configure:interfaces> show eth0: IPv4 Addresses 192.0.2.10/24 (Primary) Active = on eth1: Active = off