Modifying VLAN interfaces - BlueCat Address Manager - 9.2.0

Address Manager Administration Guide

Locale
English (United States)
Product name
BlueCat Address Manager
Version
9.2.0

Run optional commands to enable or disable the VLAN interface, and add or remove additional IP service addresses.

To modify a VLAN interface:

  1. From Main Session mode, type configure interfaces and press ENTER.
  2. Type modify <vlan-interface> and press ENTER.
  3. Run any of the following commands:
    • Enable or disable a VLAN interface
      Adonis:configure:interface:vlan-interface> set active <on|off>
    • Add additional IP service addresses
      Adonis:configure:interface:vlan-interface> add address <ipv4|ipv6address/netmask>
    • Remove additional IP service addresses
      Adonis:configure:interface:vlan-interface> remove address <ipv4|ipv6address/netmask>
  4. Type save and press ENTER. The Administration Console saves your settings.