Removing VLAN interfaces - BlueCat Address Manager - 8.3.2

Address Manager Administration Guide

prodname
BlueCat Address Manager
version_custom
8.3.2

Remove a VLAN interface tagged to a parent interface. Removing all VLAN interfaces disables VLAN Tagging.

Note: You cannot remove a parent interface that is tagged with one or more sub-interfaces (such as VLAN or bond). Remove all sub-interfaces before attempting to remove a parent interface.
Note: VLAN customers might require the Primary Service IP on a VLAN interface, and as such will need to remove the IPv4 address on eth0. For more information, refer to Removing an IPv4/IPv6 address.

To remove a VLAN interface:

  1. From Main Session mode, type configure interfaces and press ENTER.
  2. Type remove <vlan-interface> and press ENTER.
  3. At the prompt, type <Y\y> and press ENTER.
The Administration Console immediately deletes the VLAN interface.
Note: Manually restart DHCP service after adding VLAN interfaces

Currently, a known issue exists whereby DHCP service will not listen on any newly added VLAN interfaces. As a workaround, you must manually restart DHCP service from the Address Manager user interface. For details, refer to Start/Stop/Restart DHCP Service.

For more information on this issue, refer to article 15300 on BlueCat Customer Care.