Remove a VLAN interface tagged to a parent interface. Removing all VLAN interfaces disables VLAN Tagging.
Note: You cannot remove a
parent interface that is tagged with one or more sub-interfaces
(such as VLAN or bond). Remove all sub-interfaces before
attempting to remove a parent interface.
Note: VLAN customers might require
the Primary Service IP on a VLAN interface, and as such will
need to remove the IPv4 address on eth0. For more information,
refer to Removing an IPv4/IPv6 address.
To remove a VLAN interface:
- From Main Session mode, type configure interfaces and press ENTER.
- Type remove <vlan-interface> and press ENTER.
- At the prompt, type <Y\y> and press ENTER.
The Administration Console immediately deletes the VLAN
interface.
Note: Manually
restart DHCP service after adding VLAN
interfaces
Currently, a known issue exists whereby DHCP service will not listen on any newly added VLAN interfaces. As a workaround, you must manually restart DHCP service from the Address Manager user interface. For details, refer to Start/Stop/Restart DHCP Service.
For more information on this issue, refer to article 15300 on BlueCat Customer Care.