Removing VLAN interfaces - BlueCat Address Manager - 9.1.0

Address Manager Administration Guide

prodname
BlueCat Address Manager
version_custom
9.1.0

Remove a VLAN interface tagged to a parent interface. Removing all VLAN interfaces disables VLAN Tagging.

Note: You cannot remove a parent interface that is tagged with one or more sub-interfaces (such as VLAN or bond). Remove all sub-interfaces before attempting to remove a parent interface.
Note: VLAN customers might require the Primary Service IP on a VLAN interface, and as such will need to remove the IPv4 address on eth0. For more information, refer to Removing an IPv4/IPv6 address.

To remove a VLAN interface:

  1. From Main Session mode, type configure interfaces and press ENTER.
  2. Type remove <vlan-interface> and press ENTER.
  3. At the prompt, type <Y\y> and press ENTER.
The Administration Console immediately deletes the VLAN interface.
Note: Manually restart DHCP service after adding VLAN interfaces

Currently, a known issue exists whereby DHCP service will not listen on any newly added VLAN interfaces. As a workaround, you must manually restart DHCP service from the Address Manager user interface. For details, refer to Starting, stopping, and restarting DHCP service.

For more information on this issue, refer to article 15300 on BlueCat Customer Care.