Removing an IPv4/IPv6 address - BlueCat Integrity - 9.3.0

Address Manager Administration Guide

Product name
BlueCat Integrity

Remove an IPv4/IPv6 address and equivalent netmask.

Available interfaces on Address Manager and DNS/DHCP Server are:
  • Address Manager—eth0, eth1 (network redundancy; hardware appliances only)
  • DNS/DHCP Server—eth0, eth1 (xHA Backbone), eth2 (Dedicated Management), eth3 (hardware appliances only), bond0*, vlan-interface** (IPv4 address only)

    *Only available once a bonding interface has been created (port bonding on hardware appliances only).

    **Only available when VLAN interfaces have been configured.

To remove an IP address:

  1. From Main Session mode, type configure interfaces and press ENTER.
  2. Type modify <interface> and press ENTER.
  3. Type remove address <ipv4 or ipv6 address/netmask> and press ENTER.
  4. Type save and press ENTER. The Administration Console saves your settings.
  5. Type exit and press ENTER until you return to Main Session mode.
The IP address will no longer be available.