Setting an IPv4 address - BlueCat Address Manager - 9.0.0

Address Manager Administration Guide

prodname
BlueCat Address Manager
version_custom
9.0.0

Configure an IPv4 address, netmask, and default gateway.

Running the set address command automatically configures the Primary Service IPv4/IPv6 address. Use caution if modifying interfaces from the Administration Console as running the set address command will overwrite any existing Primary Service IPs, resulting in a loss of service.

Configure an IPV4/IPv6 address and netmask from within the set address command using CIDR notation.

Available interfaces on Address Manager and DNS/DHCP Server are:
  • Address Manager—eth0, eth1 (network redundancy; hardware appliances only)
  • DNS/DHCP Server—eth0, eth1 (xHA Backbone), eth2 (Dedicated Management), eth3 (hardware appliances only), bond0*, vlan-interface** (IPv4 address only)

    *Only available once a bonding interface has been created (port bonding on hardware appliances only).

    **Only available when VLAN interfaces have been configured.

Note: If you are changing an existing IPv4/IPv6 address and/or its netmask, ensure that both remain valid with the existing gateway. If the new address/netmask combination is invalid, the Administration Console will prompt you that the existing Gateway will be cleared when you save your settings.
Note: Upon initial configuration, the Address Manager server restarts after saving interface settings (Address Manager only).

To configure an IPv4 address and netmask:

  1. From Main Session mode, type configure interfaces and press ENTER.
  2. Type modify <interface> and press ENTER.
  3. Type set address <ipv4address/netmask> and press ENTER.
  4. Type save and press ENTER. The Administration Console saves your settings.
  5. Type exit and press ENTER until you return to Main Session mode.
Once you have set the IP address and netmask and saved your settings, you must set the default IP gateway from Network Configuration mode.