Configure your DNS Edge site with a static DNS server IP, a static IPv4 address and gateway, and user information.
Before you begin
- The site image has been installed in your ESX environment and is powered off.
- Launch the VMware VSphere Client.
- From your resource pool, right-click the site image and select Edit Settings. The Virtual Machine Properties window opens.
- From the Virtual Machine Properties window, select the Options tab.
- Under Settings, select General then click Configuration Parameters.
- Locate the setting ethernet.pciSlotNumber, and make note
of the value. You will need this to set the value of the
guestinfo.interface.0.name parameter in the next step. This is
usually 192, but it's important to confirm. Attention: You must set the value of guestinfo.interface.0.name with the correct ethernet.pciSlotNumber. A missing or incorrect value may result in an error.Note: You must prepend ens to the value from ethernet.pciSlotNumber when adding it to guestinfo.interface.0.name. For example, if the ethernet.pciSlotNumber value is 192, the value entered for guestinfo.interface.0.name must be ens192.Depending on the hypervisor platform, the virtual network interface might change. The following outlines some commonly seen values:
- ens192—commonly seen by the DNS Edge Service Point
- ens160—used by VMware Gov (vmnet 3 is disabled) and Intel E1000 cards
- ens224—used by Vmnet2 enhanced
To determine your virtual network interface, restart your Service Point and monitor the console for the interface value.
- From the Configuration Parameters window, click
Add Row to add each of the following
guestinfo.dns.server.0 188.8.131.52 guestinfo.dns.server.1 192.0.2.2 guestinfo.interface.0.ip.0.address <IPv4address/CIDR> guestinfo.interface.0.route.0.gateway <IPv4gateway> guestinfo.interface.0.role private guestinfo.interface.0.name ens<ethernet.pciSlotNumber> guestinfo.interface.0.route.0.destination 0.0.0.0/0 guestinfo.interface.0.dhcp no
- Click OK.
- From the Virtual Machine Properties window, click OK.
- Power on the site VM. Note: Upon powering on the site VM, the value for ethernet.pciSlotNumber might change, resulting in an incorrect interface name configuration. Verify that the ethernet.pciSlotNumber value on the SP hasn't changed. If the value has changed, power off the VM and reconfigure the guestinfo.interface.0.name parameter to the value that was reassigned to ethernet.pciSlotNumber.