Configuring DNS/DHCP Server settings - Adaptive Applications - BlueCat Gateway - 3.0.0

Device Registration Portal

prodname
BlueCat Gateway
version_custom
3.0.0

Configure settings for your DNS/DHCP Server.

Specify the DNS/DHCP Server information needed to establish a connection between DRP and the DNS/DHCP Server appliance.

  1. Under BlueCat DHCP Server(s) Connection Settings, set the following parameters:
    • Server(s)—Click Add and enter the IP address of your DNS/DHCP Server appliance then click Add Item. If you are using:
      • Standalone DNS/DHCP Server—add the physical IP address of the DNS/DHCP Server.
      • xHA—add the virtual IP (VIP) address instead of the physical IP address of each DNS/DHCP Server.
      • Failover—add the physical IP addresses of each DNS/DHCP Server in the failover cluster.
    • Username—enter the username that the DRP server uses to communicate with all DNS/DHCP Server servers. The same username must exist on all DNS/DHCP Servers.
    • Password—enter the password that the DRP server uses to communicate with all DNS/DHCP Server servers. The same password must exist on all DNS/DHCP Servers.
    • Test—click Test to validate if the DRP server can connect to DNS/DHCP Server using settings defined in the above sections. This must be done before proceeding to the next section of the configuration settings.
  2. Click Next.

Proceed to the next section to configure Blacklist settings.