Once you have configured the workflow in BlueCat Gateway, you can configure the Discovery
& Visibility GCP Adaptive Application to continuously monitor your GCP environment
for changes to virtual networks, virtual machines, and load balancers.
To enable continuous monitoring, you must populate all information in the GCP
Credentials and Visibility Options section of the
workflow. Once you start discovery, the monitoring settings are applied and GCP
information is captured for the selected GCP project in the Visibility Status
& History section. The following image displays information
populated in this section.

Visibility Management
Once you select the
Enable Visibility After Discovery checkbox
in the
Visibility Options section, a new visibility task is
added to the
Visibility Management table. You can configure
multiple visibility jobs within the same resource group. When you start the
discovery and visibility within the same resource group on a different
configuration, a new visibility job is added to the
Visibility
Management table and a new record is added in the
Visibility Status table.
Attention: If you
have stopped a visibility job and restart the job, the visibility job does not
detect changes that have been made in the cloud environment from the time that
the visibility job was stopped. If you have stopped a visibility job, BlueCat
recommends running a discovery job to retrieve the latest changes to the cloud
environment and then restarting the visibility job to continuously monitor for
additional changes.
The following image shows multiple visibility jobs within the Visibility
Management table.