Installing LiveWire Core 1200 - LiveWire

LiveWire Core 1200 Quick Start Guide
ft:locale
en-US
Product name
LiveWire

To install LiveWire Core 1200:

  1. Place LiveWire Core 1200 on a flat surface, or mount it in a standard 19-inch equipment rack.
  2. Connect a power cable to each of the two power outlets at back of the unit.
    Note: LiveWire Core 1200 has two redundant high-efficiency “hot-swappable” power supplies. If a power module fails, it should be replaced immediately. If your LiveWire Core 1200 is under warranty, please contact Technical Support to arrange for a replacement power supply.
  3. Plug the other end of the power cables to an AC outlet.
    Warning: Important! This device has more than one power cord. Disconnect ALL power supply cords before servicing.

    AVERTISSEMENT: Cet appareil a plus d´une cordon d´alimentation. Débranchez TOUTES les cordons d´alimentation avant l´entretien.

Connecting network cables

LiveWire Core 1200 includes Gigabit Ethernet ports and Integrated Remote Access Controller (iDRAC) ports used for remotely accessing and troubleshooting LiveWire Core 1200. See LiveWire Core 1200 front / back panels for the location of these ports.

To connect network cables:

  • Use a standard Ethernet cable to connect these ports to your network.
Tip: To reach LiveWire Core 1200 through an SSH connection, you can use an Ethernet cable connected directly between the Gigabit Ethernet port on LiveWire Core 1200 and your PC or laptop. LiveWire Core 1200 eth0 port is configured at the factory to have a DHCP IP address with a fail over to 192.168.1.21. The PC or laptop must be configured to be on the same IP subnet.

System Fans

LiveWire Core 1200 has multiple cooling fans that are used to cool the system chassis. If any one of the fans fail, it should be replaced immediately. If your LiveWire Core 1200 is under warranty, please contact LiveAction Technical Support to arrange for a replacement fan.

Important: The chassis top cover must be properly installed in order for the cooling air to circulate correctly through the chassis and cool the components.
Warning: Important! Slide/rail mounted equipment is not to be used as a shelf or a work space.

AVERTISSEMENT: Le matériel monté sur rails/coulisseaux ne doit pas être utilisé comme étagère ou espace de travail.