See the illustrations and descriptions of the LiveWire Core 1300 front and back panel in the sections below.
Front Panel
| Item | Ports, Panels or Slots | Description |
|---|---|---|
| 1 | Left control panel | Contains the system health, system ID, and the status LED indicator. |
| 2 | Drives | Enables you to install drives that are supported on your system. |
| 3 | Right control panel | Contains the power button with integrated power LED, 1 x VGA port, 1 x 2.0 USB port, iDRAC Direct (Micro-AB USB) port, and the iDRAC Direct status LED. |
| 4 | VGA | Enables you to connect a display device to the system. |
| 5 | Information tag | The Express Service Tag is a slide-out label panel that contains system information such as Service Tag, NIC, MAC address, and so on. If you have opted for the secure default access to iDRAC, the Information tag will also contain the iDRAC secure default password. |
Back Panel
| Item | Ports, Panels or Slots | Icon | Description |
|---|---|---|---|
| 1 | BOSS | N/A | Insert BOSS blank when the BOSS module is not used. |
| 2 | Power supply unit (PSU1) |  |
PSU1 is the primary PSU of the system. |
| 3 | PCIe expansion card riser 1 (slot 1) | N/A | The expansion card riser enables you to connect PCI Express expansion cards.For more information, see the Expansion card installation guidelines section. |
| 4 | PCIe expansion card riser 4 (slot 2) | N/A | The expansion card riser enables you to connect PCI Express expansion cards.For more information, see the Expansion card installation guidelines section. |
| 5 | Power supply unit (PSU2) |  |
PSU2 is the secondary PSU of the system. |
| 6 | VGA port |  |
Enables you to connect a display device to the system. |
| 7 | USB 2.0 port |  |
The USB port is 4-pin, 2.0-compliant. This port enables you to connect USB devices to the system. |
| 8 | USB 3.0 port |  |
The USB ports are 9-pin, 3.0-compliant. These ports enable you to connect USB devices to the system. |
| 9 | Dedicated iDRAC9 Ethernet port |  |
Enables you to remotely access iDRAC. |
| 10 | OCP NIC card |  |
The OCP NIC card supports OCP 3.0. The NIC ports are integrated on the OCP card which is connected to the system board. |
| 11 | NIC ports | N/A | The NIC ports that are integrated on the LOM card provide network connectivity
which is connected to the system board.Dell DPU card to be installed in the
riser. Note: The system allows either LOM card or MIC card to
be installed in the system.
|