The LiveAdmin utility on LiveWire lets you view and configure a variety of settings from the LiveAdmin views in the left-hand navigation pane of the utility. To learn more about each of the LiveAdmin views, go to the appropriate section below:
- Dashboard: The Dashboard view provides you with some very basic information about the system. See Dashboard.
- Authentication: The Authentication view lets you change the password for LiveWire. See Authentication.
- Monitor: The Monitor view displays the health of the overall system. See Monitor.
- Network: The Network view lets you configure the primary network interfaces network settings and the hostname of the system. See Network.
- LiveWire: The LiveWire view lets you configure Centralized Management, Factory Reset, Backup, Restore, Proxy, SFTP, SNMP, and Synthetics for the appliance. See LiveWire.
- Support: The Support view lets you download logs from the system that would be helpful in troubleshooting issues. See Support.
- Remote Syslog: The Remote Syslog view lets you configure a remote syslog server that receives all system logs. See Remote Syslog.
- Time: The Time view lets you configure the system’s Timezone and NTP servers. See Time.
- TLS: The TLS view lets you change the self-signed certificates that LiveAdmin and Omnipeek use for HTTPS. See TLS.
- Update: The Update view lets you update the appliance using a software update package. See Update.
- Administrator: The Administrator context menu in the upper right lets you restart LiveWire, power off LiveWire or log out from the LiveAdmin utility. See Restart and power off.
Important: LiveWire comes pre-configured to obtain its IP
address via DHCP. The IP address is required to configure LiveWire, as described
below.
Note: If an IP address is not assigned to LiveWire by the DHCP server
within two minutes of being connected to the network, LiveWire defaults to a static
address of 192.168.1.21.