To send the LiveFlow telemetry data that LiveNX or ThreatEye uses for its platform, you must use Omnipeek to first create a new LiveFlow capture and then configure the settings for that capture to send LiveFlow telemetry to either the LiveNX and/or ThreatEye platforms.
Note: Scroll down in the capture options to see LiveFlow settings for
Template Refresh Interval and Options Template Refresh Interval. These
settings let you configure the amount of time (in seconds) LiveWire Virtual sends template
information to LiveNX. The templates provide the instructions to LiveNX on how to interpret
the template data records in the exported LiveFlow data. The default is set to 600 seconds
(10 minutes). If you make any changes to your template settings, it will take the specified
number of seconds for the changes to take effect. If you recently connected LiveWire Virtual
to the network, it may take up to 600 seconds for LiveNX and ThreatEye to see the LiveFlow
data from LiveWire Virtual. You may want to adjust the settings to the desired
intervals.