Configure settings for your DNS/DHCP Server.
Specify the DNS/DHCP Server information needed to establish a connection between DRP and the DNS/DHCP Server appliance.
-
Under BlueCat DHCP Server(s) Connection Settings, set the
following parameters:
- Server(s)—Click Add and enter the IP
address of your DNS/DHCP Server appliance then click Add Item.
If you are using:
- Standalone DNS/DHCP Server—add the physical IP address of the DNS/DHCP
Server.
- xHA—add the virtual IP (VIP) address instead of the physical IP address
of each DNS/DHCP Server.
- Failover—add the physical IP addresses of each DNS/DHCP Server in the
failover cluster.
- Username—enter the username that the DRP server uses to communicate with all DNS/DHCP Server servers. The same
username must exist on all DNS/DHCP Servers.
- Password—enter the password that the DRP server uses to communicate with all DNS/DHCP Server servers. The same
password must exist on all DNS/DHCP Servers.
- Test—click Test to validate if the DRP server can connect to DNS/DHCP Server using settings defined
in the above sections. This must be done before proceeding to the next section of the
configuration settings.
-
Click Next.
Proceed to the next section to configure Blocklist settings.