Viewing the DNS Edge Service Point v3 health and configuration - BlueCat Integrity - 9.3.0

Once you've configured a DNS Edge service point on a supported DNS/DHCP Server, you can view the service point health and configuration details in the service point diagnostics output.

1. Select the Servers tab. Tabs remember the page you last worked on, so select the tab again to ensure you're on the Configuration information page.
2. Under Servers, click a server name.
3. Click the server name menu and select Service Configuration.
4. From the Service Type drop-down menu, select Edge service point.
5. Click to expand the Edge Service Point Status section.

   Review the output to monitor the service point status and diagnostics. If you've successfully configured the service point, "spStatus": "GOOD" shows in the first line of the output. The service point is ready to process all incoming IPv4 DNS queries and try to resolve it using its defined forwarder(s).

   Tip: Click View as Text to view the contents of the service point configuration file in a new browser page. This allows you to easily copy or save the contents as a text file.

   Tip: Alternative method of viewing the service point diagnostics output

   To view the diagnostics output, you can also use the following API call:

   http://<service point IPv4 address>/v1/status/spDiagnostics

   Note: The service point diagnostics output is available on any IPv4 address attached to the Service Interface (eth0).

   For information on additional details you can find in the diagnostics output, refer to Service point diagnostics API in the DNS Edge API Guide or the Edge Online Help.