Setting the default gateway - BlueCat Integrity - 9.5.0

Address Manager Administration Guide

Locale
English
Product name
BlueCat Integrity
Version
9.5.0

Set the default IPv4/IPv6 gateway after setting IPv4/IPv6 address and netmask/prefix.

You must first set the IPv4/IPv6 address and netmask/prefix in interface Configuration mode before setting the default gateway.
Note:
  • You can't configure interface and network settings of DNS/DHCP Server appliances that are part of a functioning xHA pair. Configure interface and network settings before creating a high availability pair.
  • You can't configure interfaces if the DNS/DHCP Server is under Address Manager control. Remove the DNS/DHCP Server from Address Manager control to configure interfaces.
  • You can't configure interfaces if network redundancy (bonding) is enabled. Disable redundancy from the Administration Console to configure interfaces. Disabling bonding will also remove the DNS/DHCP Server from Address Manager control.

To set the default gateway

  1. From Main Session mode, type configure network and press ENTER.
  2. Type set default-gateway <ipv4|ip6address> and press ENTER. If your gateway doesn't match your interface, you will receive an error. Enter the set gateway command again with the correct gateway address, or modify the IP address in Interfaces Configuration mode.
  3. Type save and press ENTER. The Administration Console saves your settings.
  4. Type exit and press ENTER until you return to Main Session mode.
After you have configured the interface and network options the Address Manager web interface should be available on the network.
IPv4 gateway example:
Proteus:> configure network
Proteus:configure:network> set default-gateway 192.0.2.1
Proteus:configure:network> save
Proteus:configure:network> exit
IPv6 gateway example:
Proteus:> configure network
Proteus:configure:network> set default-gateway 2001:db8::AC10:FE01
Proteus:configure:network> save
Proteus:configure:network> exit