Re-applying certificates - BlueCat Integrity - 9.4.0

Quickly re-apply your custom certificates if enabling/disabling HTTP or HTTPS or if you need to re-authenticate replaced servers on your network.

1. Select the Administration tab. Tabs remember the page you last worked on, so select the tab again to ensure you're on the Administration page.
2. Under User Management, click Secure Access.
3. Under General, complete the following:
   • Select Server—by default, this is the IP address of a standalone Address Manager server. If running Address Manager in replication, use the drop-down menu to select the IP address of Primary or Standby Address Manager servers.
   • HTTP—from the drop-down menu, select either Enable, Disable, or Redirect to HTTPS.
     Note: Redirect to HTTPS

     Selecting Redirect to HTTPS will redirect users to HTTPS if they attempt to access Address Manager using HTTP. You must have HTTPS enabled to use Redirect to HTTPS.

     • If the Address Manager domain name is configured to resolve to an IPv6 address, enabling Redirect to HTTPS will redirect the domain name in the URL to an IPv6 address, resulting in an unknown certificate warning in your browser. For more information, refer to knowledge base article 5978 on BlueCat Customer Care.
   • HTTPS—from the drop-down menu, select Enable.
     Important: Disabling HTTPS

     You can't disable HTTPS if HTTP is configured to redirect to HTTPS.

4. Under Server Certificate Settings, select Custom.
5. Select Re-apply.
6. Click Update. The Confirm Web Access Configuration opens.
7. Under Confirm Configuration, verify your changes.
   Listed changes will include the IP address of the Address Manager server, HTTPS or HTTPS status (enable/disable), and certificate type.
8. Click Yes. The Address Manager server will be temporarily unavailable as the changes are committed and the server restarts.